Hinderer Hardware Kit: XM-24 - Titanium Working Finish

Hinderer folders are easy to disassemble and change the configuration or make upgrades. One of the coolest features about their folders is that you can customize them to make your's look just how you want it to. This hardware kit comes with all the hardware you need to replace your XM-24 specific hardware with these stainless steel Working Finish versions. Designed for XM-24. See parts commonality below. 

Kit contains:

• One (1) 'B-1' pivot screw (Fits XM-18 3.5 Inch, XM-24, Jurassic, MP-1, Half Track, Eklipse)
• One (1) Lockbar Stabilizer w/stainless screw
• Three (3) 'A-10' Scale Screws (XM-18 3.5 inch, XM-24)
• Three (3) 'F-14' Handle Nuts (XM-24 only)
• Three (3) 'Charlie' Stand Offs (XM-2, XM-18 3.5 inch FATTY)

Please note: For those apes out there, install carefully. Use of the wrong tools or incorrect installation may bugger up the finish or ruin a piece! Use the correct tools and take your time, and you will have a super sweet looking knife! Obviously DLC is tough, but if ya start mashin' on these with steel tools, you will mar them up!