ULTICLIP: UltiLink System - Full Quick Release Mount Kit

ULTICLIP's UltiLink system has two major goals: Provide a hot-swappable mounting system for your knives and gear, and allow said mounting system to be configured on the fly to optimize carry position and access for different components. To accomplish this, there are two main elements to the system that work together to pull it off, the Lock and Pinion. The "Lock" acts as the base unit, where you want your gear to sit. The "Pinion" mounts to your gear (knife, pouch, whatever), and is the point that connects your gear in position with the Lock.

The UltiLink Lock is the "base" unit for the system. This is the part that acts as the home dock, mounted on wherever you want the dock to be. Common usage puts the Lock on a belt, anywhere there are rows of molle webbing, on hard surfaces that you can trill into, or pretty much anywhere you can think of and can rig up. The Lock features a 12-position interface for the Pinion, and a flared quick release handle with slot for lanyard pull. To attach gear to the Lock, simply pull the spring-loaded handle out, slot in your Pinion-mounted knife or gear, and release the handle. To unmount your gear, pull the handle, and pull your gear away. This system includes ready to go mounting solutions for molle panels, belts and more. The included slotted mounting hardware makes molle a breeze and will help hard-mount to many surfaces. Or, if you are feeling like it, you can hard mount the Lock to just about anything you can screw it or stick it to!

The UltiLink Pinion is the interface connecting the Lock to the gear you are mounting. In a nutshell, you connect the Pinion to your gear, and then clip the Pinion to the Lock base. The genius of this system is that anything you can mount a Pinion too, you can usually attach to the lock. On top of that, the Pinion can be rotated on the fly in 30 degree increments, allowing the perfect angle on your gear. For instance, if you want to attach your knife to a chest rig with the handle positioned straight up, It's ready to go. But say it's not quite right and you wish it was angled a little to one side - no sweat! Simply unlock the Pinion, rotate it, and re-lock it! The Pinion features chunky "teeth" that allow an easy, tactile and solid lock so you won't be fumbling for the right position. This can be done on the fly in seconds, so no tools or unmounting gear to get it just right. This same system allows you to configure each setup for the mission on hand. Say you want to swap that knife for an extra magazine or a different pouch? No problem - just unclip the knife, position your new pouch that has a Pinion attached, and lock it in! Done, no tools needed. This system includes two Pinions, allowing you to mount up two different pieces of kit (or mount a pinion on two sides of one item for an ambidextrous configuration), as well as the hardware to mount to most sheaths, molle-interface pouches, and more.

UltiLink System Contents:

1. UltiLink Lock (1)
2. Lock Hook and Loop strap w/non-slip backer (1 set)
3. Slotted mounting plates for Lock and Pinion assembly (4)
4. Lock mounting hardware (1 complete set)
5. Pinion Clip plates (4)
6. Ultilink Pinion base (2)
7. Standard length Pinion mounting hardware (2 sets)
8. Longer length Pinion mounting hardware (1 set)
9. Screws, posts and rubber washers for attaching gear to Pinion mounts (6 sets)

Expansion kits are available separately to give you more Pinions and more Locks, allowing you to hot swap more gear and to more places, maximizing your configurability and letting you keep your preferred gear with you at all times.